Type SH™ Hard Panel Nuts - Unified
Hard Panel Nuts - Type SH™
- Installs into thin, harder, high strength steel materials (high strength steel sheets at 975MPA maximum ultimate tensile)
- Allows overall weight reduction for all vehicles
- Provides lower installed cost
- Unplated threads may be oversized sized as permitted by thread standards to accept minimum plating thickness of .00020”/.0051 mm
- Addresses environmental concerns
- Smaller outer diameter
- Lighter weight
- Flush on reverse side of panel
- Close to edge of panel mounting
- No embossing required
- Hardened nut material provides stronger thread strength
- Can be installed automatically using press or in-die technology
Item # |
Thread Size |
A (Shank) Max. |
Hole Size in Sheet + .003 - .000 |
E ± .010 |
Fastener Material |
CAD |
|---|---|---|---|---|---|---|
| SH-0420-1X | Thread Size N/A .250-20 (1/4-20) | A (Shank) Max. N/A .054 in | Hole Size in Sheet + .003 - .000 N/A .344 in | E ± .010 N/A .440 in | Fastener Material N/A Hardened Alloy Steel |
CAD
N/A 
|
| SH-0420-2X | Thread Size N/A .250-20 (1/4-20) | A (Shank) Max. N/A .087 in | Hole Size in Sheet + .003 - .000 N/A .344 in | E ± .010 N/A .440 in | Fastener Material N/A Hardened Alloy Steel |
CAD
N/A
|
| SH-0518-1X | Thread Size N/A .313-18 (5/16-18) | A (Shank) Max. N/A .054 in | Hole Size in Sheet + .003 - .000 N/A .413 in | E ± .010 N/A .500 in | Fastener Material N/A Hardened Alloy Steel |
CAD
N/A
|
| SH-0518-2X | Thread Size N/A .313-18 (5/16-18) | A (Shank) Max. N/A .087 in | Hole Size in Sheet + .003 - .000 N/A .413 in | E ± .010 N/A .500 in | Fastener Material N/A Hardened Alloy Steel |
CAD
N/A
|
| SH-0616-1X | Thread Size N/A .375-16 (3/8-16) | A (Shank) Max. N/A .087 in | Hole Size in Sheet + .003 - .000 N/A .500 in | E ± .010 N/A .623 in | Fastener Material N/A Hardened Alloy Steel |
CAD
N/A
|
